Waterproof Shark Special Auto Car Radio s Stronger Signal Piano Suitable For Volkswagen VW Polo Van Variant

Waterproof Shark fin

By DA

Features and specifications:

Waterproof shark fin made from ABS plastic. It is coated in piano and comes in 12 colors. Features a 3M adhesive for a strong hold.

Note:The shark bottom hole measures 9.8 x 5.2 cm. Please e sure your base is smaller than that to ensure fit. If your base is larger, please order the super shark as it can fit a larger base.

Color

Showcase

PET-S cable for a stronger signal.

5 colors silica ring

White and pearl white comes with a white silica ring.Silver comes with a silver silica ring.Gray and dark gray comes with gray silica ring.Light red and deep red comes with red silica ring.Other colors come with a black silica ring.

Piano , ABS plastic

Bright surface, non-fading, ble ABS plastic

Package include

1 Shark fin 1 PET-S cable1 3M adhesive1 pair copper screw and nut

Easy to install

① Stick the 3M adhesive onto the bottom of the shark fin.② Remove the .③ Tighten screw and nut on the base.④ Carefully align the shark fin and pre down for 2 minutes to aure adhesion.

Dimension

Shark fin: length 16.4 cm (6.5 inch), width: 7.9 cm (3.1 inch), height: 6.7 cm (2.6 inch)Bottom hole: length: 9.8 cm (3.9 inch), width: 5.2 cm (2 inch)

Pack

Product photo

FAQ:Question 1:The shark same color with the car color?Answer 1:The shark fin color very close the color,however, the car due to long-term exposure to outdoor, erosion by rain and snow,the color has changed, so impoible exactly the same as color,hope you understand that.Question 2:How about the radio signal effect after installation?Answer 2:This using purification copper fittings,through our tested,the signal close .Question 3:What should be note when installing?Answer 3:Clean around base,be sure without water or dust,first connect the cable and base,test the radio,if it is ok,than installing,heating 3M adhesive with hair dryer before you install,it will become soft,viscosity will increase,only have one chance to paste,so be sure to alignment the positionpreing 3 minutes after pasted,keep dry in 2 days.